End Play on A Brison 2.4??
05-09-2007, 10:09 PM
#2
Senior Member
My Feedback: (4)
Join Date: Jul 2002
Location: Somewhere,
DC
Posts: 9,825
Likes: 0
Received 0 Likes
on
0 Posts
RE: End Play on A Brison 2.4??
Pull the hub off with a puller.
Pull the crank forward into the case.
Push the tapered piece back against the bearing race.
Put the hub back on the tapered piece, tighten a prop on the hub..No more end play...If the crank seems tight a slight tap on the end with a plastic or brass hammer will loosen it up..
Pull the crank forward into the case.
Push the tapered piece back against the bearing race.
Put the hub back on the tapered piece, tighten a prop on the hub..No more end play...If the crank seems tight a slight tap on the end with a plastic or brass hammer will loosen it up..
