YAK 54 65" Kit build question
06-07-2007, 10:36 AM
#1
Member
Thread Starter
My Feedback: (1)
Join Date: Mar 2004
Location: houston,
TX
Posts: 59
Likes: 0
Received 0 Likes
on
0 Posts
YAK 54 65" Kit build question
the build was going well, and then i got to building the wing. I believe i understand the instructions, but want to double check before I start gluing. the following step is where the question begins:
5. Glue each rib to the lower spar at exactly the proper angle using the laser cut "Rib Angle Guide" provided making sure each rib is fully seated. The ribs should tilt toward the tip just slightly. Note that the rear mounting tab on R1 and the notches on R3 and R4 will face upward at this time (right wing panel). When repeating this step for the left wing panel, the R1 tab and R3/R4 notches will face downward! Use thick CA to tack glue the rib trailing edges to the jig.
which direction does the mounting tab on R1 face when building the right wing (upside down as state in the instructions).
the notches mentioned for R3 and R4 face which direction, towards the ceiling or towards the building board?
thank you,
Jason
5. Glue each rib to the lower spar at exactly the proper angle using the laser cut "Rib Angle Guide" provided making sure each rib is fully seated. The ribs should tilt toward the tip just slightly. Note that the rear mounting tab on R1 and the notches on R3 and R4 will face upward at this time (right wing panel). When repeating this step for the left wing panel, the R1 tab and R3/R4 notches will face downward! Use thick CA to tack glue the rib trailing edges to the jig.
which direction does the mounting tab on R1 face when building the right wing (upside down as state in the instructions).
the notches mentioned for R3 and R4 face which direction, towards the ceiling or towards the building board?
thank you,
Jason
