Community
Search
Notices
RC Car General Discussions This forum is for all general discussions related to radio control cars. Check forums below for more specific categories if applicable.

Savage Break in Questions

Thread Tools
 
Search this Thread
 
Old 07-02-2007, 10:51 PM
  #1  
_aaron_
Member
Thread Starter
 
Join Date: Jun 2007
Location: Federal Way, WA
Posts: 38
Likes: 0
Received 0 Likes on 0 Posts
Default Savage Break in Questions

I'm through 5 tanks...

Truck has drastically improved from tank 1!!!

I have turned the needle approximately 1/2 turn clockwise during the last 2 tanks...

However, the truck still seems sluggish... and lacking of torque, and speed...

On pavement it hits 3/4 throttle and that's it...
It is blowing white smoke still, not as much as the first tank, but still quite a bit... and it leaves oil on the pavement when i "floor" it...
It seems like 3/4 throttle is all it gets... although the servo does go fully open.
Do i need to adjust the needle more?

I see video's of people pulling wheelies on demand and mine isnt close to doing that...

Also on the grass is boggs down... grass is fairly long though...


How do i know when it is adjusted correctly?

Savage X SS 4.6 on last half of fifth tank.

-Aaron
Old 07-02-2007, 11:19 PM
  #2  
Nick2618
 
Nick2618's Avatar
 
Join Date: Mar 2007
Location: Sarasota, FL
Posts: 3,671
Likes: 0
Received 0 Likes on 0 Posts
Default RE: Savage Break in Questions

Well if yu are done with break in and start leaning it out more. Just keep leaning hsn until no more prefomance gain or smoke stops comming out exaust. Then tune lsn. If you have a temp gauage it will help tune and monitor your engine.
Old 07-02-2007, 11:22 PM
  #3  
_aaron_
Member
Thread Starter
 
Join Date: Jun 2007
Location: Federal Way, WA
Posts: 38
Likes: 0
Received 0 Likes on 0 Posts
Default RE: Savage Break in Questions

At what point do I know the HSN is set correctly?
Old 07-02-2007, 11:28 PM
  #4  
nothinbetr2do
 
Join Date: Feb 2006
Location: elkton, MD
Posts: 3,657
Likes: 0
Received 0 Likes on 0 Posts
Default RE: Savage Break in Questions

do you have a temp gauge? after breack in you should slowly(1/8 turns) lean out the high needle. and then do the pintch test on the low needle. you should be in the temps of 230-280 f. hope that helps
Old 07-02-2007, 11:48 PM
  #5  
Nick2618
 
Nick2618's Avatar
 
Join Date: Mar 2007
Location: Sarasota, FL
Posts: 3,671
Likes: 0
Received 0 Likes on 0 Posts
Default RE: Savage Break in Questions

If you dont have a gauge just keep leaning out like i said until no prefoamance gain or no smoke. After you reach either richen it up a 1/8 of a turn and then it should be good. Also put a drop of water on the head if it boils right off it is to lean. Right now it sounds like you are far away form being lean.
Old 07-03-2007, 12:09 AM
  #6  
_aaron_
Member
Thread Starter
 
Join Date: Jun 2007
Location: Federal Way, WA
Posts: 38
Likes: 0
Received 0 Likes on 0 Posts
Default RE: Savage Break in Questions

Thanks guy's, I'll try leaning some more tomorrow!
Old 07-03-2007, 02:45 PM
  #7  
Neil E
Senior Member
 
Neil E's Avatar
 
Join Date: Jun 2005
Location: Sachse, TX
Posts: 430
Likes: 0
Received 0 Likes on 0 Posts
Default RE: Savage Break in Questions

Try this, read [link=http://www.*********.org/cars_eng-tuning.htm]Nitro Tuning[/link]
Old 07-03-2007, 05:24 PM
  #8  
_aaron_
Member
Thread Starter
 
Join Date: Jun 2007
Location: Federal Way, WA
Posts: 38
Likes: 0
Received 0 Likes on 0 Posts
Default RE: Savage Break in Questions

OK.. i leaned it out some more...

It got better but now when i give it full throttle it accellerates.... then hesitates and slows down... Sounds like it bogs down...?
I let off and go to idle, it stumbles, then idles back to normal...

The last 20 seconds of fuel the thing screams like a lion... so i know it can do much better...

Still will not get teh front off the ground (unless it's teh last 20 secs of fuel)
Old 07-03-2007, 08:13 PM
  #9  
Neil E
Senior Member
 
Neil E's Avatar
 
Join Date: Jun 2005
Location: Sachse, TX
Posts: 430
Likes: 0
Received 0 Likes on 0 Posts
Default RE: Savage Break in Questions

Read the Nitro Tuning again. Sounds like you can lean it out more. The engine will start to come into full power by the time you have used up about a 1/2 gallon of nitro. Be patient and make small adjustments. Keep putting fuel through the engine. My last Savage took alitttle over 1/2 gallon before the engine made lots of power.

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off



Contact Us - Manage Preferences Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.