Turbine ON-Board Battery Question
#1
Thread Starter
My Feedback: (102)
Turbine ON-Board Battery Question
I am trying to find out who mkaes the red connector found on my on board battery pack on my SimJet engine. I have seen it on other models as well. I would like to find one to make a charge cord with.
Also can anyone make a reccommendation as to what rate you whould fast charge these batteries with, I am using the Hitec field charger with adjustable rate.
THanks for the info
Tommy
Also can anyone make a reccommendation as to what rate you whould fast charge these batteries with, I am using the Hitec field charger with adjustable rate.
THanks for the info
Tommy
#2
My Feedback: (60)
Turbine ON-Board Battery Question
I charge mine at 2.2 amps fast charge. But you're safe and a little on the conservative side at two times the MAH of the battery capacity. I actually cycle my battery to find out the "real" capacity before I set my fast charger as sometimes what's stated on the pack isn't what my cycling comes out to. In fact most times that's the case. I'm redoing the wireing on my RAM battery to standard Deans Connectors. That way you can make whatever leads you want. It seems to me that some of these jet guys want everything to stay to the charging leads that come with the battery. I've spent a lot of research in the past couple of months doing High Performance electric airplanes. The deans connectors are far better conductors than the connectors that come with our turbine electronic control units. My .02