southturn

I just put together a Tamiya TG10-MK2 kit with a O.S. 18TZ engine. It starts fine on starter box but when I put car on groung under load it stalls the engine. Any suggestions on why this is happening? I've adjusted the idel here and there with no luck Please help.

rcschall20

put the car up on a brick or something so the wheels are free to roll and then adjust.. may check fuel mixture

savagexx1

sounds too rich, also make sure to only lean it enough so it will just barely not stall on break in

Clear2Close

umm tune it properly

The_Collector

Check the clutch operation. Could have a spring that's too stretched or broken.