What are some good ways to remove this damn stripped hex screw !!
#26
Senior Member
My Feedback: (4)
Join Date: Aug 2004
Location: milwaukee,
WI
Posts: 1,045
Likes: 0
Received 0 Likes
on
0 Posts
RE: What are some good ways to remove this damn stripped hex screw !!
dont use red thread locker! haha anyway you could use a dremel if you had one, drill it out the rest of the way, next time use heat and if you feel the driver start to give (jump) stop and check everything out precaution is the word here. use hex drivers integy actually has a set for around $20 and they work very well and have aluminum handles I even use the hex drivers on things other then RC. strangely though you dont see too many hex drivers outside of RC.
#27
Senior Member
Join Date: Sep 2005
Location: Sammamish,
WA
Posts: 2,016
Likes: 0
Received 0 Likes
on
0 Posts
RE: What are some good ways to remove this damn stripped hex screw !!
Those cheap "Dremels" are cheap for a good reason.
I have a friend who has burnt TWO out and they don't spin at speed even approaching Dremels. If you're gonna get one, get a good, REAL, Dremel... That's what I did and it's outlasted my friends for quite a while...
I have a friend who has burnt TWO out and they don't spin at speed even approaching Dremels. If you're gonna get one, get a good, REAL, Dremel... That's what I did and it's outlasted my friends for quite a while...
#29
Member
Thread Starter
Join Date: Mar 2008
Location: Melbourne, AUSTRALIA
Posts: 88
Likes: 0
Received 0 Likes
on
0 Posts
RE: What are some good ways to remove this damn stripped hex screw !!
Got it out today. Bought an ozito $40 dollars dremel. Thank you everyone !