nofords

For those that run thru transom exhaust, what do you use for isolators and where can you get em?
I can find tips all over but nothing to hold and seal the 1/2" outlet to the transom.

If it matters much, I was hoping to use Bonzi Tips.

thanks

Slow Motion

Nofords, go to your local hobby shop and look at their silicone nitro exh. couplers made for various car eng. exh. They usually are stepped; one end smaller than the other and sometimes different colors. You might find something that will work.

coyv10

You may try automotive body plugs they come in all different sizes, avaible at auto stores and body shops

dicko

what about the tape discussied earlier on this site to insulate your pipe?

http://www.rcuniverse.com/forum/m_72...tm.htm#7288531

that should work, & you could wrap it to your desired thickness.

martno1fan

Nitro silicone exhaust tubing is what i used i found some the correct diam and thickness and it works great,if you get a snug fit it holds it also but i also put some silicon sealant round the tubing to fix it to the transom on the outside as insurance.
Mart

nofords

cool thanks. Will have a look!

mike the snake

I used those black rubber firewall grommets. Got them at my local hardware store. They work perfectly and don't seem to be bothered by the heat.

nofords

I like that idea!
Good show. thank you.