Hudy comm lathe
05-11-2003, 05:15 AM
#1
Junior Member
Thread Starter
Join Date: Feb 2003
Location: Billings, MT
Posts: 10
Likes: 0
Received 0 Likes
on
0 Posts
Hudy comm lathe
I just bought a new Hudy Tech comm lathe and diamond cutter.
When I cut the comm it is nice and shiny but seems to be quite rough.
Is this the way it should be or do I have a problem?
Thanks MILO
As I am new at this maybe someone could tell me a bit about using the lathe as the instructions are not very good.
When I cut the comm it is nice and shiny but seems to be quite rough.
Is this the way it should be or do I have a problem?
Thanks MILO
As I am new at this maybe someone could tell me a bit about using the lathe as the instructions are not very good.
