G-26 tweeking
#1
Senior Member
Thread Starter
Join Date: Sep 2002
Location: Ontario, Canada
Posts: 130
Likes: 0
Received 0 Likes
on
0 Posts
G-26 tweeking
HI all. I have been running my RCIGN G-26 for a bit now with about 3 gal. of gas through it and it has been great. The last time I was out though I noticed it would now sputter and cut in and out when I was coming out of a loop or pulling out of a steep dive , after leveling off it would be fine again. This being my first gas engine I am not sure what carb. adj. I should make.
Thanks Pete
Thanks Pete
#2
Senior Member
Join Date: Jan 2002
Location: Arcen, , NETHERLANDS
Posts: 6,571
Likes: 0
Received 2 Likes
on
2 Posts
RE: G-26 tweeking
Lean out the H-needle little by little, until the sputter goes away.
It is caused by the high G-forces working on the regulator membrane. This causes the mixture to go very slightly richer. So if you experience this, your mixture is on the verge of 4-stroking rich, which is quite a bit too rich.
It is caused by the high G-forces working on the regulator membrane. This causes the mixture to go very slightly richer. So if you experience this, your mixture is on the verge of 4-stroking rich, which is quite a bit too rich.