csm hlg 200
05-24-2003, 07:23 AM
#1
Member
Thread Starter
Join Date: May 2003
Location: l, UNITED KINGDOM
Posts: 37
Likes: 0
Received 0 Likes
on
0 Posts
csm hlg 200
Has any one got one of these?
Im ready to put all my seperates together but Im unsure of the wiring from the tail esc.
As I look at gyro it has orange/red/brown which goes to receiver.But next to that are 3 prongs,how do I know which is positive and negative?
any help most appreciated
Im ready to put all my seperates together but Im unsure of the wiring from the tail esc.
As I look at gyro it has orange/red/brown which goes to receiver.But next to that are 3 prongs,how do I know which is positive and negative?
any help most appreciated
05-24-2003, 10:45 AM
#2
Member
Join Date: Apr 2003
Location: RayleighLondon, UNITED KINGDOM
Posts: 54
Likes: 0
Received 0 Likes
on
0 Posts
csm hlg 200
Hi,
I had the same problem, basically from the front you want the orange wire to the right and you DO NOT connect the other two wires I cut mine. the reason I think is that otherwise the tail ESC will try and provide power to the receiver but this is already being done by the main motors ESC.
Also the manual that came with my HLG200 was for the HLG200 that comes in a proper plastic case but mine is the lightened one and it needed to be on its side so the CSM writing is sideways not up the correct way although the manual didn't mention this. Well I couldn't see it anyway.
I hope this all makes sense but I'm feeling a little hungover to day so it might not.
Cheers,
David
I had the same problem, basically from the front you want the orange wire to the right and you DO NOT connect the other two wires I cut mine. the reason I think is that otherwise the tail ESC will try and provide power to the receiver but this is already being done by the main motors ESC.
Also the manual that came with my HLG200 was for the HLG200 that comes in a proper plastic case but mine is the lightened one and it needed to be on its side so the CSM writing is sideways not up the correct way although the manual didn't mention this. Well I couldn't see it anyway.
I hope this all makes sense but I'm feeling a little hungover to day so it might not.
Cheers,
David
