Magic Assembly Question
#1
Thread Starter
Magic Assembly Question
I am ready to put on the horizontal stab on my Magic. However, I noticed the stab is somewhat pointed and will not fit flush against the fuselage which is flat. Do I need to sand the stab to fit or just glue it on anyway. The instructions aren't exactly clear about the fit. TIA
#2
Senior Member
My Feedback: (16)
Join Date: Mar 2002
Location: San Diego, CA
Posts: 2,586
Likes: 0
Received 0 Likes
on
0 Posts
Magic Assembly Question
I actually never thought about sanding a flat spot in mine, but I don't see how it could hurt as long as you didn't take too much off.
I just made sure mine was centered before I put any epoxy on it. I marked it with pencil so I'd know where it lined up. I *****ed some small holes in the wood to give the epoxy some more "bite" and then went for it.
Mike
I just made sure mine was centered before I put any epoxy on it. I marked it with pencil so I'd know where it lined up. I *****ed some small holes in the wood to give the epoxy some more "bite" and then went for it.
Mike