Cutting decals and designs
#1
Thread Starter
My Feedback: (7)
Cutting decals and designs
Couple of fellow fliers have PM about how I cut out the decals on the BH T-28. I have an old drafting table that I bought a piece of "Safety" glass the size of that I cut all my covering and trim on. I went to my local glass dealer and asked for his advice on the best to use and this was his recommendation. It is the same glass tha is used on glass top tables and does not scratch easily. Been using the same glass for 10 plus years and not a scratch on it.
Cutting compound curves is a dream, sharp edges and smooth cuts, since the knife does not imbed itself in the under layer.
Give it a try you will be glad you did.
JimO
Cutting compound curves is a dream, sharp edges and smooth cuts, since the knife does not imbed itself in the under layer.
Give it a try you will be glad you did.
JimO