Panzl set up
#2
RE: Panzl set up
Chuck,
You can go to the website and download the Panzl ARF instructions on the PANZL page. Below is the link to the instructions that will give you all the setup info both for IMAC and 3D
http://www.jtecrc.com/Pictures/Plane...RAandPANZL.pdf
Al
You can go to the website and download the Panzl ARF instructions on the PANZL page. Below is the link to the instructions that will give you all the setup info both for IMAC and 3D
http://www.jtecrc.com/Pictures/Plane...RAandPANZL.pdf
Al
#8
My Feedback: (17)
Join Date: Oct 2003
Location: lexington,
KY
Posts: 1,228
Likes: 0
Received 0 Likes
on
0 Posts
RE: Panzl set up
IMAC setup
ele ~12° w/ 45%expo
Ailerons start at about 25° adjust until you have the perfect snap roll w/ 55%expo
Rudder ~ 40° on 2 rates 40 w/ 55% expo for hammer heads and rollers with about 20 to 25° w/ 50% expo for the rest of imac.
I use 2 rates right now for imac
rate 1 snap rolls and all flying except hammer heads and rollers
rate 2 hammers and rollers with the only change is rudder
ele ~12° w/ 45%expo
Ailerons start at about 25° adjust until you have the perfect snap roll w/ 55%expo
Rudder ~ 40° on 2 rates 40 w/ 55% expo for hammer heads and rollers with about 20 to 25° w/ 50% expo for the rest of imac.
I use 2 rates right now for imac
rate 1 snap rolls and all flying except hammer heads and rollers
rate 2 hammers and rollers with the only change is rudder