Which prop for OS 120 FS for 3D
#1
Senior Member
Thread Starter
Join Date: Jan 2003
Location: Ottawa, Canada and The Caribbean.
Posts: 391
Likes: 0
Received 0 Likes
on
0 Posts
Which prop for OS 120 FS for 3D
Hi Guys,
I have a Great Planes 60 size Extra 300S with an OS 120 FS on it.
It flies really well and does really nice blenders as far as 3D goes, but I cant get it to hover. It either climbs out or falls out when I try to hover, I think I need a prop with a much lower pitch and larger diameter. I would like to torque roll it. Does anyone have this plane/engine combo and torques it. I have extended rudder and elevator control surfaces on this plane. CG is at its edge for stable flying.
Thanks,
I have a Great Planes 60 size Extra 300S with an OS 120 FS on it.
It flies really well and does really nice blenders as far as 3D goes, but I cant get it to hover. It either climbs out or falls out when I try to hover, I think I need a prop with a much lower pitch and larger diameter. I would like to torque roll it. Does anyone have this plane/engine combo and torques it. I have extended rudder and elevator control surfaces on this plane. CG is at its edge for stable flying.
Thanks,
#3
Senior Member
Thread Starter
Join Date: Jan 2003
Location: Ottawa, Canada and The Caribbean.
Posts: 391
Likes: 0
Received 0 Likes
on
0 Posts
Which prop for OS 120 FS for 3D
Thanks outssider for the reply. I will try it.
Did you have this setup on an OS 120?
Striker.
Did you have this setup on an OS 120?
Striker.
#6
Senior Member
Thread Starter
Join Date: Jan 2003
Location: Ottawa, Canada and The Caribbean.
Posts: 391
Likes: 0
Received 0 Likes
on
0 Posts
Which prop for OS 120 FS for 3D
Thanks so much LoveBipes.
I was at the local hobby shop today. They did not have any of the APC 16X6 so I bought the APC 16X7. Do you think that the pitch difference is critical? I built and installed an on board OptiGlow for this airplane as well. I am hoping to get some 3D sticktime on this Extra before moving onto my 27% H9 Edge 540 with a ZDZ 50 for a powerplant.
Thanks again,
Striker.
I was at the local hobby shop today. They did not have any of the APC 16X6 so I bought the APC 16X7. Do you think that the pitch difference is critical? I built and installed an on board OptiGlow for this airplane as well. I am hoping to get some 3D sticktime on this Extra before moving onto my 27% H9 Edge 540 with a ZDZ 50 for a powerplant.
Thanks again,
Striker.