Zenoah G-62 throttle linkage
#1
Junior Member
Thread Starter
My Feedback: (9)
Join Date: Dec 2001
Location: New Smyrna Beach,
FL
Posts: 11
Likes: 0
Received 0 Likes
on
0 Posts
Zenoah G-62 throttle linkage
I've just installed a Zenoah G-62 and have sat here the past hour trying to figure out how to install the throttle linkage. This is my first gas engine. I don't know how to install the bellcrank so that everything will be linear. Also, I don't get how the bellcrank works with the G-62--because the throttle arm is at a angle. Any help would be appreciated! A pic or diagram would help more. Thanks.
email: [email protected]
email: [email protected]
#2
My Feedback: (1)
Join Date: Mar 2002
Location: Northfield Center, OH
Posts: 2,205
Likes: 0
Received 2 Likes
on
2 Posts
Zenoah G-62 throttle linkage
I just got a new G62 and it came with an extra carbureter spacer that turns the carb so the throttle pushrod can go straight into the firewall. It's also thinner, so I didn't have to cut a hole in the cowl (Ziroli P47). It was already on the engine. The other one was in the box. Maybe you can check with Zenoah or Horizon about it. Also B&B Specialties might be able to help. They have a thin carb mount for the G62, but I don't know if it turns the carb. They also have linkage kits for that pesky throttle angle.