25% SU-26 setup help needed
09-03-2009, 02:52 PM
#1
Senior Member
Thread Starter
Join Date: May 2007
Location: Tampa,
FL
Posts: 167
Likes: 0
Received 0 Likes
on
0 Posts
25% SU-26 setup help needed
Hello,
I am building a 25% Su-26 with a DLE30 motor which I purchased from Valleyview RC. http://www.valleyviewrc.com/Sukhoi%20Su-26m.htm
I am planning on using an A123 pack for the rx to keep things simple and light. Any suggestions on where to buy it and what size?
Any suggestions on servos? Valleyview RC recommended HS645. Do you think they would be sufficient or should I look at the HS5645 or HS7985. The plane should weight around 10-11 LBS when completed. I like to 3D and fly pattern. I would hate to build a good airplane and put a cheap servo into it causing a poor flying airplane.
Thanks!
I am building a 25% Su-26 with a DLE30 motor which I purchased from Valleyview RC. http://www.valleyviewrc.com/Sukhoi%20Su-26m.htm
I am planning on using an A123 pack for the rx to keep things simple and light. Any suggestions on where to buy it and what size?
Any suggestions on servos? Valleyview RC recommended HS645. Do you think they would be sufficient or should I look at the HS5645 or HS7985. The plane should weight around 10-11 LBS when completed. I like to 3D and fly pattern. I would hate to build a good airplane and put a cheap servo into it causing a poor flying airplane.
Thanks!
09-08-2009, 08:28 PM
#2
RE: 25% SU-26 setup help needed
ORIGINAL: qspilotcmh
Hello,
I am building a 25% Su-26 with a DLE30 motor which I purchased from Valleyview RC. http://www.valleyviewrc.com/Sukhoi%20Su-26m.htm
I am planning on using an A123 pack for the rx to keep things simple and light. Any suggestions on where to buy it and what size?
Any suggestions on servos? Valleyview RC recommended HS645. Do you think they would be sufficient or should I look at the HS5645 or HS7985. The plane should weight around 10-11 LBS when completed. I like to 3D and fly pattern. I would hate to build a good airplane and put a cheap servo into it causing a poor flying airplane.
Thanks!
Hello,
I am building a 25% Su-26 with a DLE30 motor which I purchased from Valleyview RC. http://www.valleyviewrc.com/Sukhoi%20Su-26m.htm
I am planning on using an A123 pack for the rx to keep things simple and light. Any suggestions on where to buy it and what size?
Any suggestions on servos? Valleyview RC recommended HS645. Do you think they would be sufficient or should I look at the HS5645 or HS7985. The plane should weight around 10-11 LBS when completed. I like to 3D and fly pattern. I would hate to build a good airplane and put a cheap servo into it causing a poor flying airplane.
Thanks!
The 645's should be fine unless you want digital servos then go with the 5645's.
Here is a link to Wild Hare RC they have an A123 package for sale.
http://www.wildharerc.com/html/specials.html
Pete
