Removing ball ends?
#2
Senior Member
Join Date: Apr 2009
Location: CHICAGOLAND,
IL
Posts: 1,856
Likes: 0
Received 0 Likes
on
0 Posts
RE: Removing ball ends?
Not familiar with those shocks but if you mean to get the metal balls out of the plastic ends...
I use some pliers or needlenose and rest one jaw on the plastic on one side and the other jaw on the metal and squeeze.
Or just put the metal ball on a table with a bolt in it to have some height and rest the jaws of the pliers on the plastic around it and push down.
I use some pliers or needlenose and rest one jaw on the plastic on one side and the other jaw on the metal and squeeze.
Or just put the metal ball on a table with a bolt in it to have some height and rest the jaws of the pliers on the plastic around it and push down.
#3
Junior Member
Join Date: Aug 2006
Location: Pottstown, PA
Posts: 18
Likes: 0
Received 0 Likes
on
0 Posts
RE: Removing ball ends?
they also make special plyers for doing that. Look for the helicopter stuff in you LHS. they are u shaped on one jaw and the other jaw is flat with a little dot near the end opposite the U. Takes a little time to get used to them but thye save a lot of time, that's why the helicopter guys use them since there are so many joints on a copter.