factory settings?
#2
Senior Member
Join Date: Jan 2007
Location: auburn ,
CA
Posts: 116
Likes: 0
Received 0 Likes
on
0 Posts
RE: factory settings?
if you crank the main needle (hsn) out you will see a line on the shaft. that is the stock setting for that, the mid needle goes flush. and i think flush will be good on the lsn to.
#3
Senior Member
Join Date: Jan 2008
Location: Red Oak,
TX
Posts: 464
Likes: 0
Received 0 Likes
on
0 Posts
RE: factory settings?
hsn 2 3/4 turns out, lsn 6 1/2 turns out, idle .5mm
http://www.novarcproducts.com/teamas...edmanuals.html
http://www.novarcproducts.com/teamas...edmanuals.html