PowerBox Royal Failsafe w/Futaba 2.4 - Help
#1
Thread Starter
My Feedback: (24)
PowerBox Royal Failsafe w/Futaba 2.4 - Help
I am trying to find guidance on the proper way to set up the failsafe (F/S) on a PowerBox Royal using 2 Futaba 2.4 receivers and a 12Z transmitter. Thus far, I have plugged each F/S patch cord into each receiver on an unused channel (CH 10). CH 10 is not utilized in either receiver and I assigned it to a rotary knob.
Should I now enable the F/S function for CH 10 in the transmitter .... and turn it off for all other functions ?
Thanks. Bob
Should I now enable the F/S function for CH 10 in the transmitter .... and turn it off for all other functions ?
Thanks. Bob
#2
My Feedback: (23)
RE: PowerBox Royal Failsafe w/Futaba 2.4 - Help
Hey Bob
just pick a free chanell like the ch10 you have. now the trick is to make this chanel go -100 on fail safe.
the rotary know can do the job. go to fail safe anable the F/S fanction for chanel 10 and use your rotary knob to set up the fail safe of ch10 at -100.
then go on fanction ..and where is the control of ch 10(rotary knob in our case) you NULL it just for safety.so you wont accidently comant a f/s.
now no knob swich trim or stick controls ch10
now get a servo and put it in ch10 in each receiver and shut off radio and confirm they move to -100.
plug all on and you are ready to go!
also you can select the (online) receiver before take off by removing others f/s chanel..and plug it back in
this way i find the best place for my receiver in the fuse and then swich to a one receiver setup
forgive my poor english
George
just pick a free chanell like the ch10 you have. now the trick is to make this chanel go -100 on fail safe.
the rotary know can do the job. go to fail safe anable the F/S fanction for chanel 10 and use your rotary knob to set up the fail safe of ch10 at -100.
then go on fanction ..and where is the control of ch 10(rotary knob in our case) you NULL it just for safety.so you wont accidently comant a f/s.
now no knob swich trim or stick controls ch10
now get a servo and put it in ch10 in each receiver and shut off radio and confirm they move to -100.
plug all on and you are ready to go!
also you can select the (online) receiver before take off by removing others f/s chanel..and plug it back in
this way i find the best place for my receiver in the fuse and then swich to a one receiver setup
forgive my poor english
George
#5
Senior Member
Join Date: Apr 2004
Location: Oxted, UNITED KINGDOM
Posts: 139
Likes: 0
Received 0 Likes
on
0 Posts
RE: PowerBox Royal Failsafe w/Futaba 2.4 - Help
ORIGINAL: DelGatoGrande
forgive my poor english
George
forgive my poor english
George
Your English is better than some English people I know!! and I learnt some thing to, can't be bad!
Thank you!
<br type="_moz" />