pst 1300 question
#1
Senior Member
Thread Starter
Join Date: Jul 2004
Location: FAIRFIELD ,
CA
Posts: 258
Likes: 0
Received 0 Likes
on
0 Posts
pst 1300 question
HI
I just got a Xicoy fadec and i was wondering if i can use the fuse and switch from the original tems ecu on a pst 1300 i would like to use because ecu battery hard to get to i have it set up that when the switch is off i can charge the battery
thanks
Arden
I just got a Xicoy fadec and i was wondering if i can use the fuse and switch from the original tems ecu on a pst 1300 i would like to use because ecu battery hard to get to i have it set up that when the switch is off i can charge the battery
thanks
Arden
#3
Senior Member
Thread Starter
Join Date: Jul 2004
Location: FAIRFIELD ,
CA
Posts: 258
Likes: 0
Received 0 Likes
on
0 Posts
RE: pst 1300 question
LGM Graphix
hi
I will as soon as i can get this all put back together the old tems never did work sat around for 2.5 years when i set it up it never worked .
did your freind get the cdfor jr radio
Arden
hi
I will as soon as i can get this all put back together the old tems never did work sat around for 2.5 years when i set it up it never worked .
did your freind get the cdfor jr radio
Arden
#6
Senior Member
Thread Starter
Join Date: Jul 2004
Location: FAIRFIELD ,
CA
Posts: 258
Likes: 0
Received 0 Likes
on
0 Posts
RE: pst 1300 question
The RPM sensor is universal and it should be mounted with the curvature matching with the turbine inlet. Fuse and Switch are no longer needed with the Fadec since the main power is switched on with the Rx power. You can use the switch and fuse if you want to.
Cheers,
B777
_____________________________
PST Jets Thailand; Skymaster Jet Thailand
Cheers,
B777
_____________________________
PST Jets Thailand; Skymaster Jet Thailand