3 in 1
12-02-2009, 07:02 PM
#1
Junior Member
Thread Starter
Join Date: Nov 2009
Location: Lake Hopatcong, NJ
Posts: 4
Likes: 0
Received 0 Likes
on
0 Posts
3 in 1
So I have an Axe CPv3 and the 3 in 1 is fried. I have a great planes c-35 and a c-12 speed conrollers. Can I just use a y off the channel that the 3 in 1 went into and use the c-35 for the main rotor and the c-12 for the tail?
12-06-2009, 03:04 PM
#2
Senior Member
My Feedback: (1)
Join Date: Aug 2003
Location: Benton Harbor,
MI
Posts: 1,027
Likes: 0
Received 0 Likes
on
0 Posts
RE: 3 in 1
Sort of, yes. You need a gyro to run the tail motor. It goes between the receiver and the c-12. You will also need to remove the red wire on the servo connection going to the gyro. See this:
http://manuals.hobbico.com/hmx/hmxe04-gyro-manual.pdf
http://manuals.hobbico.com/hmx/hmxe04-gyro-manual.pdf
12-06-2009, 10:08 PM
#3
Junior Member
Thread Starter
Join Date: Nov 2009
Location: Lake Hopatcong, NJ
Posts: 4
Likes: 0
Received 0 Likes
on
0 Posts
RE: 3 in 1
ORIGINAL: PilotLight
Sort of, yes. You need a gyro to run the tail motor. It goes between the receiver and the c-12. You will also need to remove the red wire on the servo connection going to the gyro. See this:
http://manuals.hobbico.com/hmx/hmxe04-gyro-manual.pdf
Sort of, yes. You need a gyro to run the tail motor. It goes between the receiver and the c-12. You will also need to remove the red wire on the servo connection going to the gyro. See this:
http://manuals.hobbico.com/hmx/hmxe04-gyro-manual.pdf
So it is possible then?
01-04-2010, 07:59 PM
#5
Junior Member
Thread Starter
Join Date: Nov 2009
Location: Lake Hopatcong, NJ
Posts: 4
Likes: 0
Received 0 Likes
on
0 Posts
RE: 3 in 1
ORIGINAL: jzanutto
what are the symptoms, how did you know it was the 3 in 1?
what are the symptoms, how did you know it was the 3 in 1?
Since I posted this thread, I have replaced the 3 in 1 with a great plains c-25 and c-12 with a gyro.
Its much better now and it all cost about the same as a new 3 in 1.
