had a fire
#1
Senior Member
Thread Starter
My Feedback: (1)
Join Date: Feb 2010
Location: roanoke rapids, NC
Posts: 430
Likes: 0
Received 0 Likes
on
0 Posts
had a fire
I had a fire in my shop where I kept my RC trucks. They were not burned, but water was shot on my Tmaxx with a 2.5r in it.I did not realize it had gotten wet until several months after it happened. It took me a while to rebuild my shop and just now getting back to be able to start messing with my trucks. My engine was locked up. I was able to get it turning today, but it feels rough in a couple of spots. I have it soaking in oil. Have any of you guys ever had an issue like this?
#2
Senior Member
Join Date: Jul 2011
Location: Manitowoc ,
WI
Posts: 216
Likes: 0
Received 0 Likes
on
0 Posts
RE: had a fire
yea i had my 3.3 go tight on me. i let it sit for about a year without putting afterrun oil in it and i tried to turn it over after a year it was tight, so i just took it apart and soaked and cleaned everything in the motor i got it running after a while but it was still a pain. just take the whole motor apart and take your time to clean it
#9
Senior Member
My Feedback: (3)
Join Date: Jul 2004
Location: Norwood,
OH
Posts: 22,101
Likes: 0
Received 0 Likes
on
0 Posts
RE: had a fire
It was probably old fuel, not water, that caused this. Take the engine apart and soak the crankcase in new fuel to loosen stuff up. Sometimes fuel can turn acidic and eat up the bearings, too...so be prepared to buy a new crankcase or bearings if this is the case.
Sorry about the fire in your shop, that sucks.
Sorry about the fire in your shop, that sucks.
#10
Senior Member
Thread Starter
My Feedback: (1)
Join Date: Feb 2010
Location: roanoke rapids, NC
Posts: 430
Likes: 0
Received 0 Likes
on
0 Posts
RE: had a fire
I plan to mess with it some tonight. I have not had a lot of time to mess with it. Lots of prople on vacation at work, I am working to cover their absense.
#11
Senior Member
Thread Starter
My Feedback: (1)
Join Date: Feb 2010
Location: roanoke rapids, NC
Posts: 430
Likes: 0
Received 0 Likes
on
0 Posts
RE: had a fire
I have not had time to work on my truck. I was offered 100 bucks per hour to work on some machines that I once worked on at a company that shut down. A man purchased the machines and wants them running. SO, I am thinking new motor!!!! What would you guys suggest for my Tmaxx. I am not thinking crazy power, just somethinf I don't have to tune every 10 minutes.