MVVS 1.6 gas, any experience?
#1
Junior Member
Thread Starter
My Feedback: (1)
Join Date: Jan 2002
Location: Olympia, WA
Posts: 7
Likes: 0
Received 0 Likes
on
0 Posts
MVVS 1.6 gas, any experience?
Has anyone used one of these, or heard any reports on it? I'm looking for a lightweight gasser for a 10 pound plane. These come in around 2 pounds w/o ignition battery.
Thanks for the input!
Rick Glatthaar
Thanks for the input!
Rick Glatthaar
#2
My Feedback: (14)
Join Date: Jan 2002
Location: St. Joseph,
MO
Posts: 121
Likes: 0
Received 0 Likes
on
0 Posts
MVVS 1.6 gas, any experience?
I have no experience with the MVVS but you can hardly go wrong with the RCS140 on a 10# (or less) plane. I am very pleased with the operation of mine. Comes in rear or side exhaust.
Go here to see it:
http://rcshowcase.com/RCS%20Engines.htm
-ed
[email protected]
Go here to see it:
http://rcshowcase.com/RCS%20Engines.htm
-ed
[email protected]
#3
My Feedback: (12)
Join Date: Dec 2001
Location: Yellow Springs,
OH
Posts: 389
Likes: 0
Received 0 Likes
on
0 Posts
mvvs gasser
Here is a real good link to one of the guys on these boards that has set one up in a h9 cap. Sounds like a real nice motor. I am waiting for a dealer in Germany to get his in stock to order one. The motor has gone through some improvements since John's motor in the following link.
Jeff
http://home.flash.net/~jecramer/mvvs160.htm
Jeff
http://home.flash.net/~jecramer/mvvs160.htm
#6
My Feedback: (198)
Join Date: Feb 2002
Location: El Reno, OK
Posts: 6,707
Likes: 0
Received 0 Likes
on
0 Posts
My MVVS
Mine came from Topmodel in France. My choice....ordered on a Friday, shipped following Weds. Still in transit...total USD cost, incl. shipping $281.02 That is, of course, engine, ignition, carb, and that horrible tincan choke/muffler. MVVS Header/Pipe came from Pe Reivers, was $54, plus $10 shipping - from The Netherlands.
#7
My Feedback: (506)
Join Date: Dec 2001
Location: St. Thomas, VIRGIN ISLANDS (USA)
Posts: 2,429
Likes: 0
Received 0 Likes
on
0 Posts
MVVS 1.6 gas, any experience?
I've bought two of these from Just Engines in the UK. I paid just over $290 each, including shipping.
I'm still waiting on my mufflers from Bisson, so I haven't run them yet. They look good, though.
I'm still waiting on my mufflers from Bisson, so I haven't run them yet. They look good, though.
#9
Senior Member
My Feedback: (1)
Join Date: Dec 2001
Location: Hammond,
IN
Posts: 3,262
Likes: 0
Received 0 Likes
on
0 Posts
MVVS 1.6 gas, any experience?
Anyone have prop/rpm numbers for the MVVS 1.6 on various mufflers? I understand the stock muffler is very restrictive on power. I assume the engine is stronger than the RCS/Moki 1.4 in either side or rear exhaust configuration....true? Is the ignition auto advance or fixed timing? Has the ignition proved reliable over time..or do they go ftttzzz?
#10
My Feedback: (8)
MVVS 1.60
Hi guys, I have not only the 1.60 but also the 2.15 gassers from MVVS. They put out good power and run like a clock. I have the 1.60 installed in a GP 1/4 scale Giles 202 weighing @ 11 3/4 lbs, pulls strong although it is not fully broke in as of yet. I can turn a APC 16X6 9100 RPM's on a BCM muffler. I have it from a very reliable source that SlimLine is working on a muffler as well. Has great throttle transition and pulls very strong on the lower RPMS as well. Best of all only pennies a flight.
The 2.15 is installed in a MidWest Super Stinker Pitts weighing in @ 14lbs, I only have 2 short flights this bird so I have not rung her out as of yet to see what kind of power she has. But I can say it I feel very good about the power capabilities for this one as well. Feel free to drop me a line if ya have any questions. [email protected]
The 2.15 is installed in a MidWest Super Stinker Pitts weighing in @ 14lbs, I only have 2 short flights this bird so I have not rung her out as of yet to see what kind of power she has. But I can say it I feel very good about the power capabilities for this one as well. Feel free to drop me a line if ya have any questions. [email protected]
#11
My Feedback: (12)
Join Date: Dec 2001
Location: Yellow Springs,
OH
Posts: 389
Likes: 0
Received 0 Likes
on
0 Posts
MVVS 1.6 gas, any experience?
I have been waiting for Tino in Germany to receive his shippment of the 1.6 gas so I can purchase from him. I believe he is selling the 1.6 for about 250$ shipped, That is if mvvs hasnt raised there prices with the upgrades that they have made to this motor. Tino has responded to each email I have sent the very next day and has written that he has sent quite a few motors to the usa. I have a copy of the email that he sent to me which has his email address and web site on it along with a special that he was having on the 2.15 gas. If anyone is interested just drop me an email at [email protected] and I will forward you a copy.
Jeff
Jeff