Servo-Bind Plug
10-18-2020, 09:40 AM
#1
Servo-Bind Plug
Hey guys i asked this question on facebook but i feel like i should ask it again before i destroy a servo. On facebook they said chop the wires, remove the middle wire, and connect the negative to the positive. But none of them showed me how they themselves did it , which is something i would like to see so i know im not just breaking an old servo for no reason. So if you did it or know someone who did then please let me know. I want to try and get this done when i can, hopefully before my parts arrive.
10-18-2020, 10:37 AM
#2
Are you trying to make a bind plug?
If so, just take an old/dead servo, cut off the lead, remove the middle wire, and attach the outside wires to each other. It's not the negative and positive its the negative (ground) and signal and voila you have a bind plug.
If so, just take an old/dead servo, cut off the lead, remove the middle wire, and attach the outside wires to each other. It's not the negative and positive its the negative (ground) and signal and voila you have a bind plug.
The following users liked this post:
RustyUs (10-20-2020)
10-20-2020, 08:34 PM
#4
Thank you so much i got it done and binded but now im having other issues. the steering is drive and reverse on my remote and the trigger is left and right(update i just had to switch around the wires). But now the servo goes uncontrollable and tweaks when on. the throttle and reverse work good though
