Instuctions for .70 Katana
12-14-2005, 07:01 PM
#1
Instuctions for .70 Katana
My new 62 inch Katana came today and it looks great. Everything arrived in good conditon. I am missing the instructions though. I have built a few kits and some arfs but it would be nice to know the CG control throws etc...
12-14-2005, 07:11 PM
#2
Member
Join Date: Jul 2003
Location: aberdeen, MD,
Posts: 40
Likes: 0
Received 0 Likes
on
0 Posts
RE: Instuctions for .70 Katana
I just recieved my katana .46 v2 and same thing. No instructions. 3 months late and no instructions. C'mon guys. Give me a little hope....just a little.
12-15-2005, 04:20 AM
#5
Senior Member
My Feedback: (21)
Join Date: Mar 2003
Location: Manhattan,
NY
Posts: 9,227
Likes: 0
Received 0 Likes
on
0 Posts
RE: Instuctions for .70 Katana
The manual will be up today. Sorry for the brief delay. If you have any questions, please ask!
CG is 130MM behind the leading edge against the fuse.
Throws are maxed out on high rates, 30-45 on low rates.
CG is 130MM behind the leading edge against the fuse.
Throws are maxed out on high rates, 30-45 on low rates.
12-15-2005, 12:03 PM
#6
My Feedback: (59)
Join Date: May 2004
Location: Steeler Nation
Posts: 599
Likes: 0
Received 0 Likes
on
0 Posts
RE: Instuctions for .70 Katana
Dion, what you don't understand is....by shorting me a physical hard copy of the instructions i don't have anything to read in my reading room whilst sitting upon the throne.
LOL,
John
LOL,
John
12-15-2005, 06:53 PM
#10
My Feedback: (3)
Join Date: May 2002
Location: Beavercreek, OH,
Posts: 4,319
Likes: 0
Received 0 Likes
on
0 Posts
RE: Instuctions for .70 Katana
Ok gentlemen, we have your "throne reading room material", uh I mean the manual for the Kats now. I'm going to post a new thread here with the manual zipped. Should be up in Christmas lights in the next few minutes!
To answer the question about the cg on the Kat 70, it is 6-6.5 inches behind the leading edge at the root. Obviously 6.25" would be a good place to start. More aft equals more 3d!
To answer the question about the cg on the Kat 70, it is 6-6.5 inches behind the leading edge at the root. Obviously 6.25" would be a good place to start. More aft equals more 3d!
