Help! How do you secure kevlar on pull-pull?
03-22-2003, 11:26 PM
#1
Senior Member
Thread Starter
My Feedback: (1)
Join Date: Jan 2002
Location: Wichita Falls, TX
Posts: 240
Likes: 0
Received 0 Likes
on
0 Posts
Help! How do you secure kevlar on pull-pull?
I'm putting pull-pull on an older knife that had pushrods. I bought 100lb kevlar cable.
I've used the coated metal cord that comes with Morris kits, but have never used kevlar.
What do I do? Tie it in a knot and ca it or do I use brass tubing like you do the coated metal cable?
Thanks for the help.
I've used the coated metal cord that comes with Morris kits, but have never used kevlar.
What do I do? Tie it in a knot and ca it or do I use brass tubing like you do the coated metal cable?
Thanks for the help.
03-22-2003, 11:40 PM
#2
Senior Member
Join Date: Jan 2003
Location: Eagle River,
AK
Posts: 942
Likes: 0
Received 0 Likes
on
0 Posts
Help! How do you secure kevlar on pull-pull?
I am not a big fan of kevlar, for one it is abrasive and it has cut through my servo arms. Second it can fray
For securing it CA will work, just not too much it can make it brittle.
For securing it CA will work, just not too much it can make it brittle.
