Zenoah GT-80 question
11-04-2007, 07:18 AM
#1
Thread Starter
Zenoah GT-80 question
Does the engine mount of a GT-80 require the bolts to enter from the front or behind the firewall? In my installation, I'm going to have a lot of "stuff" behind the firewall (tank, smoke system, CO2 tank) & it will be just barely enough room to get a wrench on the engine mount nuts (assuming the GT-80's engine mount lets me install the bolts from the front with the locknuts on the backside of the firewall).
Thanks!
Thanks!
11-04-2007, 12:22 PM
#3
My Feedback: (19)
RE: Zenoah GT-80 question
ORIGINAL: Eindecker_pilot
Does the engine mount of a GT-80 require the bolts to enter from the front or behind the firewall? In my installation, I'm going to have a lot of "stuff" behind the firewall (tank, smoke system, CO2 tank) & it will be just barely enough room to get a wrench on the engine mount nuts (assuming the GT-80's engine mount lets me install the bolts from the front with the locknuts on the backside of the firewall).
Thanks!
Does the engine mount of a GT-80 require the bolts to enter from the front or behind the firewall? In my installation, I'm going to have a lot of "stuff" behind the firewall (tank, smoke system, CO2 tank) & it will be just barely enough room to get a wrench on the engine mount nuts (assuming the GT-80's engine mount lets me install the bolts from the front with the locknuts on the backside of the firewall).
Thanks!
