Building a rigger, question about sponson.
#1
Senior Member
Thread Starter
Join Date: Dec 2006
Location: Franklin,
IN
Posts: 260
Likes: 0
Received 0 Likes
on
0 Posts
Building a rigger, question about sponson.
I am building a Dumas outrigger. I am working on the right sponson. My question is: should I leave this edge where the 2 bottom pieces meet sharp as in the picture, or shold I smooth it out? The instructions dont say anything spicifically about it and there are no pictures of the bottom of the sponson. The only thing it does say is you can round the edges on the top, but all the surfaces that ride on the water should be left sharp. Anyone know what to do at this point?