Nitro engine setup and break in.
#1
Junior Member
Thread Starter
Join Date: May 2003
Location: Kimberly, Idaho
Posts: 2
Likes: 0
Received 0 Likes
on
0 Posts
Nitro engine setup and break in.
I am new to RC 1/8th scale buggy's, I'm looking for the best advice i can get on breaking in and setting up a high performance Nitro Engine for the first time?
#2
Senior Member
Join Date: Apr 2003
Location: Crawley, UNITED KINGDOM
Posts: 136
Likes: 0
Received 0 Likes
on
0 Posts
Nitro engine setup and break in.
Well not long had my gs storm... ok the shop that i bought it form ran it in for me but he reckonmended 10 full tanks before the car was poperly ran in... and slowly work it up to full throttle on ya 8th tanks.. ajustment the idle srew so that it idling nicely and trying to race off or cut out when starting..
one thing to watch is the once you properly ran it in make sure that the buggy is idling nice as can make it cut out when starting.. (happened to me not funny...)
and get a spare glow plug as they tend to go after you have finish running it in..
oh and make sure you have tightened all the srews and bolts.. as when it was being run in, two wheels from one side fell off... DOH!!
have fun...
one thing to watch is the once you properly ran it in make sure that the buggy is idling nice as can make it cut out when starting.. (happened to me not funny...)
and get a spare glow plug as they tend to go after you have finish running it in..
oh and make sure you have tightened all the srews and bolts.. as when it was being run in, two wheels from one side fell off... DOH!!
have fun...