3D wing for 84" Extra
#1
Thread Starter
My Feedback: (6)
Join Date: Sep 2004
Location: Roseville,
CA
Posts: 285
Likes: 0
Received 0 Likes
on
0 Posts
3D wing for 84" Extra
My latest project is putting a rectangular 3D style wing (18" x 82") on my 84" 50cc Extra 300 Special. It's a direct replacement for the original tapered wing (same hole spacing for the GF wing tube and anti-rotation dowels) but it's about 13% more sq inches and actually will weigh a littlle less as it's built up balsa/lite ply and the original is sheeted foam. All up weight should be just a hair over 16 lbs,
I expect it to fly similar to a Bling 3D but, hopefully without the wing coming apart.
Has any body else done anything like this before? I would like to hear of your experience. Also, I am looking for CG recommendations.
I'll post some pics when I get a little further along
Thanx
I expect it to fly similar to a Bling 3D but, hopefully without the wing coming apart.
Has any body else done anything like this before? I would like to hear of your experience. Also, I am looking for CG recommendations.
I'll post some pics when I get a little further along
Thanx
#2
My Feedback: (21)
RE: 3D wing for 84" Extra
Its been done before. A guy here took Hangar 9's 540 Edge, the blue and yellow 1.20 size I think, and used the wing off of an OMP 80" Edge. I think Mike sold him a wing kit. There is a thread on it here somewhere. Give AFSalmon a PM and he might remember the name of the thread.