Balsa Sheeting / silkspan control surfaces FW190
#1
Junior Member
Thread Starter
Join Date: Oct 2002
Location: TX
Posts: 10
Likes: 0
Received 0 Likes
on
0 Posts
Balsa Sheeting / silkspan control surfaces FW190
I'm getting ready to start a top flite FW190 and I have a few questions about finishing.
Does the balsa just need a sandable wood sealer before primer/paint is applied, or epoxy / fiberglass?
I'm thinkng of doing the control sufaces with silkspan and dope but I haven't used that in since I was a kid building little guillow's rubber flight models. Any help, ideas, reccomendations?
Also If anyone has bult this kit, any probs. or experiences would be greatly appreciated.
Thanks
[email protected]
Does the balsa just need a sandable wood sealer before primer/paint is applied, or epoxy / fiberglass?
I'm thinkng of doing the control sufaces with silkspan and dope but I haven't used that in since I was a kid building little guillow's rubber flight models. Any help, ideas, reccomendations?
Also If anyone has bult this kit, any probs. or experiences would be greatly appreciated.
Thanks
[email protected]