Don't ever stop bashing because of a broken part again!!!
#1
Senior Member
Thread Starter
My Feedback: (1)
Join Date: Oct 2002
Location: glendale,
AZ
Posts: 435
Likes: 0
Received 0 Likes
on
0 Posts
Don't ever stop bashing because of a broken part again!!!
Well, I was out messin around with my E-maxx, and it landed on it's side off of a 5 foot jump. Needless to say, I broke my front skid plate and bulkhead , but there is good news! I went home pi$$ed off because I didn't have any money to buy new crap, so I took an old solering tip, and melted the piece together, when it was melted together I took an old zip tie and used that as 'solder'. Went back out and it's still holding strong! It may not look pretty, but if you out just to have fun, this is the way to go! I wouldn't reccomend doing this on race day though, just for the simple fact that it might mess up your set-up.
#2
Senior Member
My Feedback: (2)
Join Date: Feb 2003
Location: staten island , NY
Posts: 1,515
Likes: 0
Received 0 Likes
on
0 Posts
Don't ever stop bashing because of a broken part again!!!
nice one....i might try it oneday
i knwo some parts arent any big deal to repair.....i got an extra few days out of a front arm that i crazy glued back together. it didnt last forever, but while i waited on the new one(or the money for the new one) i was able to still drive.
i bet if you crazy glued and then, do like you said, melt the plastic back together it would hold for quite a while.
i knwo some parts arent any big deal to repair.....i got an extra few days out of a front arm that i crazy glued back together. it didnt last forever, but while i waited on the new one(or the money for the new one) i was able to still drive.
i bet if you crazy glued and then, do like you said, melt the plastic back together it would hold for quite a while.