mgt 3.0 stop turning after a few wheelies
04-12-2010, 05:26 PM
Senior Member
Thread Starter
Join Date: Feb 2009
Location: HUNTSVILLE,
AL
Posts: 554
Likes: 0
Received 0 Likes
on
0 Posts
mgt 3.0 stop turning after a few wheelies
I have an mgt 3.0 that i have a big block .21 engine in it after doing bout 10 wheelies now it wont turn left or right but when i take the servo saver off the servo still work have any one else had this happen could it be a bad servo or what might it be
04-17-2010, 08:40 PM
Senior Member
Join Date: Apr 2010
Location: HIGHTSTOWN, NJ
Posts: 290
Likes: 0
Received 0 Likes
on
0 Posts
RE: mgt 3.0 stop turning after a few wheelies
SOUNDS LIKE YOU STRIPPED SERVO.GO WITH HITEC MG'S HIGH TORQUE.
04-18-2010, 12:36 AM
Senior Member
Thread Starter
Join Date: Feb 2009
Location: HUNTSVILLE,
AL
Posts: 554
Likes: 0
Received 0 Likes
on
0 Posts
RE: mgt 3.0 stop turning after a few wheelies
thats what kind i have in it and its brand new that was the frist run with it
04-18-2010, 03:10 AM
Senior Member
Join Date: Apr 2010
Location: HIGHTSTOWN, NJ
Posts: 290
Likes: 0
Received 0 Likes
on
0 Posts
RE: mgt 3.0 stop turning after a few wheelies
STOCK SERV RIGHT? JUST REPLACE IT WITH A HITEC
04-18-2010, 01:47 PM
Senior Member
Thread Starter
Join Date: Feb 2009
Location: HUNTSVILLE,
AL
Posts: 554
Likes: 0
Received 0 Likes
on
0 Posts
RE: mgt 3.0 stop turning after a few wheelies
no its not the stock its hitec one
04-18-2010, 07:24 PM
Senior Member
Join Date: Apr 2010
Location: HIGHTSTOWN, NJ
Posts: 290
Likes: 0
Received 0 Likes
on
0 Posts
RE: mgt 3.0 stop turning after a few wheelies
OH CHECK SERVO HORN THAT MIGHT BE STRIPPED , IHAVE HAD PLENTY OF METAL GEAR SERVOS AND IMO THEY ARE THE BEST
04-18-2010, 08:52 PM
Senior Member
Thread Starter
Join Date: Feb 2009
Location: HUNTSVILLE,
AL
Posts: 554
Likes: 0
Received 0 Likes
on
0 Posts
RE: mgt 3.0 stop turning after a few wheelies
did u mean the servo saver
Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts
HTML code is Off