acepec88

My Feedback: (2)

<span class="postbody">i just bought a used savage flux xl, I am running 6s 21/44 gearing, it seem slow and it hardly wheelie, did tighting the slipper and change different 2200kv motor, but still slow and not wheelie much. what could be the problem?</span>

t9dragon

My Feedback: (11)

Do you have the Castle Link? If you do set the ESC back to the stock settings. Also did the batteries come with the truck?

SyCo_VeNoM

also check if there is binding in the drive chain

ThunderbirdJunkie

My Feedback: (3)

How hot is it getting? It's possible the previous owner cooked the motor and it's demagged.

xerxes

flux xl? u meen hp?


low powerd batterys can choke out performanse, but id recomend usin castle link & gettn it on2 a pc.

da previous owner mite have turnd down max throttle from 100% to lyk 60%?


does it seem fastr in revers?

t9dragon

My Feedback: (11)

Seriously could you type using proper english.....

ThunderbirdJunkie

My Feedback: (3)

Good point about it being faster in reverse, xerxes.
There's an XL-length conversion available from HPI for the Flux, too.

Foxy

Edit: nvm, didn't read op properly.

ThunderbirdJunkie

My Feedback: (3)

BTW Ace, you're geared WAY too high...you should be running a 15t pinion on this combo as it sits depending on your actual temps after a 10 min run

steed2-inactive

i would be suspecting batteries.

Freezetron

Being used, I suspect the ESC settings have been changed

acepec88

My Feedback: (2)

i think i found the problem, I reset the esc, and i also found that one of the front drive cup is worn out near strip. thats gotta be the problems.

Freezetron

Yeah that would pretty much do it