AAAhhhhh finally 97% done cermark pitts
#1
Senior Member
Thread Starter
My Feedback: (8)
Join Date: Feb 2004
Location: Some City,
CA
Posts: 179
Likes: 0
Received 0 Likes
on
0 Posts
AAAhhhhh finally 97% done cermark pitts
as all yall can see, im ALMOST done. The engine installation was a blast! I had to rip off the monokote to get my hands to the rear of the firewall and glassed it to the fuse,but before all that I had to take away the styrofoam that was molded to the top of the fuse. What I had done is throw some drops of Thin CA to eat it all up and at the end, scraped it away so the fiberglass can lay flush on the balsa wood.
However I would like to know how this plane flies so I know what I am looking forward to when I fly it. Also, the photo of the monokote peeled off by the firewall, did you guys make a hatch there? I plan on making a hatch but worried that any fuel/oil will seep through it and into the firewall via between the hatch cover and the fuselage. Any tips appreciated in that part. Have a good one guys.
Also for those who dont know howto isntall the g26 and seek information, I posted a thread in
Giant Scale, search the forums for
Cermark Pitts g26 install.
However I would like to know how this plane flies so I know what I am looking forward to when I fly it. Also, the photo of the monokote peeled off by the firewall, did you guys make a hatch there? I plan on making a hatch but worried that any fuel/oil will seep through it and into the firewall via between the hatch cover and the fuselage. Any tips appreciated in that part. Have a good one guys.
Also for those who dont know howto isntall the g26 and seek information, I posted a thread in
Giant Scale, search the forums for
Cermark Pitts g26 install.